Research on technology of improving top-coal recovery in longwall top-coal caving mining based on BBR system
-
摘要: 对放煤工艺进行优化是提高综放开采顶煤采出率的主要途径之一。本文基于BBR研究体系,采用散体放煤试验和离散元数值计算相结合的方法,从煤岩分界面特征和顶煤放出体发育的角度研究了多口同时放煤、分段逆序放煤的散体顶煤放出规律及提高顶煤采出率的机理。研究表明:采用多口同时放煤的方式可提高顶煤采出率,多回收的部分主要来自于工作面中部的中高位顶煤;随着放煤口长度的增大,放出体体积呈线性增大,初始矸石混入点位置向放煤口上方移动,终止煤岩分界面形态逐步呈现出向已放煤侧凸出的特征;采用分段逆序放煤方式可使下端头顶煤采出率提高13.98%,且在正、逆序段衔接处可形成有利于放出体发育的煤岩分界面形态,减少了采空区残煤;逆序段放煤量增长率随逆序段长度增大呈现出先增大后减小的趋势;采用分段逆序双口同时放煤方式,可达到同时提高工作面中部和下端头顶煤采出率的目的。Abstract: The optimization of drawing parameters is one of the major ways to improve top-coal recovery in longwall top-coal caving mining.Based on the BBR system,the drawing mechanism of loosen top-coal in mutil-openings and partially reverse drawing techniques were analyzed by loose top-coal drawing experiments and distinct element numerical calculations.The results show that the top-coal recovery ratio in mutil-openings condition is larger than that in single-opening condition.The increased volume comes from the middle and upper parts of the top-coal above the central face.With the increasing of opening length,the volume of drawing body increases linearly and the rock mixed position in drawing body moves to directly above the opening;the shape of the boundary of the top coal appears the bulging characteristic toward the goaf gradually.The partially reverse drawing technique increases the top-coal recovery ratio in the lower end of the face by 13.98% compared to normal drawing technique.The shape of the boundary of the top-coal near the junction of reversed segment and normal segment is beneficial to the development of drawing body,which decreases the residual coal in the goaf.With increasing reversed segment’s length,the growth rate of the drawing volume in reversed segment decreases after an initial increasing phase.The top-coal recovery ratios in both the middle and the lower parts of the face are increased by using the partially reverse drawing technique with double-openings.
-
Key words:
- BBR /
- mutil-openings /
- partially reverse drawing /
- drawing body /
- top-coal recovery ratio
-
[1] 王家臣.厚煤层开采理论与技术[M].北京:冶金工业出版社,2009:48-50. [2] 王金华.复杂厚煤层综放开采技术与工程实践[M].北京:煤炭工业出版社,2013:221-254. [3] 王家臣.我国综放开采技术及其深层次发展问题的探讨[J].煤炭科学技术,2005,33(1):14-17. [4] Wang Jiachen.Fully mechanized longwall top coal caving technology in China and discussion on issues of further development [J].Coal Science and Technology,2005,33(1):14-17. [5] 蒋金泉,曲华,谭云亮.综放顶煤放出规律与放煤步距的离散元仿真研究[J].岩石力学与工程学报,2004,23(18):3070-3075. [6] Jiang Jinquan,Qu Hua,Tan Yunliang.Numerical simulation by distinct element code on drawing law and interval of fullymechanized coal mining with caving method [J].Chinese Journal of Rock Mechanics and Engineering,2004,23(18):3070-3075. [7] 吴锋锋,刘长友,黄炳香,等.松散细砂岩顶板下综采合理放煤步距的确定[J].煤炭科学技术,2006,34(4):52-55. [8] Wu Fengfeng,Liu Changyou,Huang Bingxiang,et al.Rational coal caving step distance setting for fully mechanized longwall top coal caving face under soft fine sandstone roof [J].Coal Science and Technology,2006,34(4):52-55. [9] 樊运策.综放工作面冒落顶煤放出控制[J].煤炭学报,2001,26(6):606-610. [10] Fan Yunce.Control on top coal caving in long wall top coal caving working face [J].Journal of China Coal Society,2001,26(6):606-610. [11] Zhang Ningbo,Liu Changyou,Pei Mengsong.Effects of caving–mining ratio on the coal and waste rocks gangue flows and the amount of cyclically caved coal in fully mechanized mining of superthick coal seams [J].International Journal of Mining Science and Technology,2015,25(1):145-150. [12] 靳文学,靳钟铭.综放合理工作面长度分析[J].太原理工大学学报,2000,31(5): 508-510. [13] Jin Wenxue,Jin Zhongming.Analysis of rational length for fully mechanised caving mining face [J].Journal of Taiyuan University of Technology,2000,31(5): 508-510. [14] Wang Jiachen,Yang Shengli,Li Yang,et al.Caving mechanisms of loose top-coal in longwall top-coal caving mining method [J].International Journal of Rock Mechanics and Mining Sciences,2014,71(10):160–170. [15] 王家臣,魏立科,张锦旺,等.综放开采顶煤放出规律三维数值模拟[J].煤炭学报,2013,38(11): 1905-1911. [16] Wang Jiachen,Wei Like,Zhang Jinwang,et al.3-D numerical simulation on the topcoal movement law under caving mining technique[J].Journal of China Coal Society,2013,38(11): 1905-1911. [17] Wang Jiachen,Zhang Jinwang,Song Zhengyang,et al.Three-dimensional experimental study of loose top-coal drawing law for longwall top-coal caving mining technology[J].Journal of Rock Mechanics and Geotechnical Engineering,2015,7(3):318-326. [18] 王家臣,张锦旺.综放开采顶煤放出规律的BBR研究[J].煤炭学报,2015,40(3): 487-493. [19] Wang Jiachen,Zhang Jinwang.BBR study of topcoal drawing law in longwall topcoal caving mining[J].Journal of China Coal Society,2015,40(3):487-493. [20] Yang Shengli,Zhang Jinwang,Chen Yi,et al. Effect of upward angle on the drawing mechanism in longwall top-coal caving mining [J]. International Journal of Rock Mechanics and Mining Sciences,2016,85(5):92-101. [21] Wang Jiachen,Zhang Jinwang,Li Zhaolong. A new research system for caving mechanism analysis and its application to sublevel top-coal caving mining [J]. International Journal of Rock Mechanics and Mining Sciences,2016,88(10):273-285. [22] 王家臣,张锦旺.急倾斜厚煤层综放开采顶煤采出率分布规律研究[J].煤炭科学技术,2015,43(12): 1-7.
点击查看大图
计量
- 文章访问数: 905
- HTML全文浏览量: 117
- PDF下载量: 179
- 被引次数: 0